Trouble with tiles

Ok. I decided to try whit tile printing and read up on the darkly labs method of using negative images and black paint.
In trying it out I always seem to get a double or offset image for some reason. I tried multiple images and types with the same result. I even used the sample image and settings.
Anyone have any idea as to why I get a double image? Normal cutting or engrave works fine so it’s not the laser.

Here are the settings I’m using.

Hi Jon,

From your settings it looks like you have your units set to mm/sec.

That means that your speed (1000mm/sec) is far too high and will be causing this issue.

Change your units to mm/min and then the settings should work.

1 Like