Darkly Labs Community

Problem with Focus calibration

Does anyone else find that when running the focus calibration with LaserBurn that at the start of the process the head drops too low and touches the card and drags it until the head starts to rise?

This always happens at the lefthand edge of the image. The card I am using is only 0.08mm thicker than that supplied with the E2.

My air assist nozzle is correctly located in the groove and the lens unit is fixed in as high as it can go in the holder. It has only happened since changing to LB from Laserweb, I have upgraded each time an update comes out, but it still does it.

Martin

Hi Martin

My E2 did the same but was cured in the software update

Hi Keith

I also have the latest version installed but still experience the problem sadly.