Darkly Labs Community

MDF Cutting Settings

3mm MDF with E2 and AA. It’s slow with slight stains. But it allow a pretty good separation. I would like to turn the AA assist down for the second pass; just on enough to clear the air off but not cool the cut. But with it on full it prevents the the surface cutting through. Future AirAssist request would be able to override default AA speed value when setting up path jobs (or what ever they are called).

Settings:

Pass 1 = 1 pass, 100% power, 100mm/m, AA ON

Pass 2 = 1 pass, 100% power, 200mm/m, AA OFF

 

1 Like

Thank you, that’s helpful. 

You don’t go lower on the 2nd pass?