Darkly Labs Community

Laser stalls since LB 8.02

Hi there,

since updating to 8.02 the laser stalls at almost every file. There are a couple of points it stalls, but always the same. Version 8.03 didn’t help.

I run LB under Win 7 at a Lenovo L512 notebook, the files are imported in DXF R12 format. The previous LB versions worked fine.

Best regards

Michael

Does it report anything in the console? You haven’t specified E1 or E2, but our new coder introduced a bug in version 0.8.02. If it’s what I think, go to the device settings, and toggle the button for M7 air assist on and back off again. In 0.8.03 it’s now a pair of radio buttons - set it to M7, and then back to M8. (M8 is supposed to be the default, because M7 is disabled on most GRBL versions, and reports an error).

Thanks for the fast response! It’s an Emblaser 2. I will try your recommendation the next time.

Best regards

Michael