Darkly Labs Community

How to use super lube?

Hello! I think its time for me to use some lube on my bearings but I have not found anything online on how to do it and where. If you could break it into steps that would be really cool! thanks!

Hi Joel,

Thanks for posting on the Darkly Labs Community page!

I have attached the instructions listed in the Emblaser 2 Users Manual, available here: https://darklylabs.zendesk.com/hc/en-us/articles/115004407087-Emblaser2-Manuals

I’ll also elaborate a little for clarity.

  1. Clean all Linear Rails with a lint free cloth.
  2. Apply a pea-sized amount of Super Lube (in total) to the rails using your finger, or a latex glove (or similar).
  3. Spread the Super Lube across the entire rail.
  4. With the machine off, slowly and gently move the Laser Carriage across each axis to circulate the  Super Lube throughout the Linear Bearings.

Don’t hesitate to get in touch if you have any questions regarding the above.

 

Best regards,

 

Lliam

Customer Support Team

D A R K L Y    L A B S

d a r k l y l a b s . c o m