Darkly Labs Community

Going to front left after job

Hi,

I am not sure if this is an Emblaser 2 issue or a Lightburn issue.  For some strange reason, out of the blue (or so it would seem), when the laser is done a job, it goes to the front left.  When I hit Home, it goes back to the back left which is the usual “home” after jobs.

What could be the cause?

Running LB 0.9.05

 

Thanks

Steve

Hi Steve,

By any chance have you possibly set a finishing position from within the ‘Move’ window?

Hi Domenic,

 

Nope.  The only thing I do in the move window is to get the starting position of the job.

Will do a little troubleshooting after I finish this job and let you know what I have found.

 

Thanks

Steve

Ok, found out what it is.  If I change the measurements from mm to in it homes to the front right.  Changing it back to mm causes it to home to back left.

 

Steve

I have brought this to the LightBurn teams attention and they will address this issue.

Thanks