Darkly Labs Community

End of job - Lightburn crashing (physically) into home stops

Morning
Just upgrade my A3 E1 to 0.9.24

When running a job the cut goes fine until the end. As the head returns to top-right home it is over running the home position and physically crashing into the X-stop. This causes it to lose position so if I re-run the job the cut is now offset.

Very strange, cannot think of a reason.

Anyone else, thanks

David

 

Hi David,

Thanks for posting on the Darkly Labs Community Site.
In order to better assist you I have created a support ticket from this enquiry, and you should receive an email shortly.

Best regards,

 

Lliam
Customer Support Team

D A R K L Y    L A B S

d a r k l y l a b s . c o m