Emblaser cutting tray?

I can’t see any markings since using the tray and as a bonus it now hides my earlier scratchings. :wink:

1 Like

Good question!
I have seen minimal surface marking on high traffic areas, however I think this could be removed with some elbow grease.
The yellow origin sticker is a little worse off, looking a tad charred where is overlaps the workspace - this has not had any impact on cutting, etc.

Thanks Lliam,
My yellow origin sticker was about 5mm off the 0,0 so I 3D printed a couple of pieces as locating references. A couple of magnets in the 3D print so they don’t move around.
I do have some “railway tracks” from when I was using the stand offs.