Darkly Labs Community

E2 ends job midway

My E2 ends the job midway and goes to home position and then the alarm stays on till I power off (green LED button) the E2.

Below is a screenshot of the console. 

image.png

This has happened a number of times with different jobs.

Can someone please assist here?

Hi Joel,

This would be an indication that your over-temperature sensor is triggering on the laser head.

The most likely cause is a build up of debris on the sensor.

Please carefully remove the plastic laser-head cover and carefully brush away any buildup on the PCB, especially under the cooling fan and lower section of the PCB.

There are small components on the board, so please be extremely careful.

Thanks Domenic…the above solution seemed to have worked for me