Darkly Labs Community

E1 Worktable, Paper, Air-blowing!

5 mm acrylic, translucent…

hole spacing: 10 mm

hole size: 2,3 mm

Rivet: 2,3 mm x 30 mm

That is very, very clever.

I tip my hat to you sir!

HI Zsolt,

Very nice…

I used to use a clear acrylic base, but noticed that over time it tends to bend due to the heat from the laser.

Hope you don’t face the same problem.

Joel.

Hello Zsolt Lorincz, What laser unit are you using as it seems a lot different to the original laser unit sent with the Emblaser ?

Regards Trevor

Hi Trevor!

I use 4W Emblaser laser.