Darkly Labs Community

E1 Power Grid Test on Plywood

I have made a power grid testing on a plywood with the 3W Laser. The specifications are:

0.1 - 45 - Fill = Fill with Stepover 0.1 mm / 45 degrees
0.3 - 45 - Fill = Fill with Stepover 0.3 mm / 45 degrees 
0.5 - 45 - Fill = Fill with Stepover 0.5 mm / 45 degrees 

0.1 - 45 - Cross Fill = Fill with Stepover 0.1 mm / 45 degrees / Cross Hatch
0.3 - 45 - Cross Fill = Fill with Stepover 0.3 mm / 45 degrees / Cross Hatch
0.5 - 45 - Cross Fill = Fill with Stepover 0.5 mm / 45 degrees / Cross Hatch

On line Power 100% with Fill with Stepover 0.1 mm / 45 degrees / Cross Hatch i do not had the courage to laser because I would not, that the laser would make a hole in the underlying table :slight_smile:

6 Likes

Nice job, thanks for taking the time to post.

Thank you for doing this test. It is exactly what I was hoping to find.

Would you be willing to post the file you used to make this?

If I can find a possibility to upload here the file, i will do it with pleasure. Unfortunately i do not understand, how to attach here a file. Any ideas?

Salvatore, If you have “Dropbox” you could upload your file to there and post a link to it here for people to download it…

Hi Jared, thanks for the information about Dropbox, but i am not friend of Dropbox and similar services. As alternative i have made an upload on my own server. The link is: http://www.transkommunikation.ch/temp/plywood_test_power_grid.zip 

Regards
Salvatore

Hi Jared, thanks for the information about Dropbox, but i am not friend of Dropbox and similar services. As alternative i have made an upload on my own server. The link is: http://www.transkommunikation.ch/temp/plywood_test_power_grid.zip 

Regards
Salvatore