Darkly Labs Community

Cutting Mats

Hello everyone,

Twice today while doing some testing with my new E2 I’ve had the material I was using shift for no apparent reason on the cutting mats.  The laser wasn’t touched while it was running but the material just moved.  I’m suspecting that it might be the air-assist causing vibrations causing the material to eventually shift.  My question is if you are using the cutting mats, what are you using to keep the material in place? Would rare earth magnets hold the  wood in place though the mats? Looking for some ideas.

Thanks!

Mark

Use a few bits of 2 sided tape on the back and you’ll be good to go!

As suggested by Brendan 2 sided tape.  I use picture framing tape as it is super thin and strong.