Darkly Labs Community

Alignment grid

Hey guys,

 

I don’t know if there’s still anyone but me active on this board, but I’ve created a basic grid for engraving onto whatever surface you use to cut/engrave off of. I just use a white piece of thick card paper, and it’s the best way I’ve found to align material before starting a job. Below is an image of the grid, which just includes a 10mm grid (offset 10mm in each direction from the very edge of the cutting envelope), a center marker, and 10mm number markers. Here’s the actual file: https://drive.google.com/open?id=1GreycVa_lw7PZjpwkZAfYms7MN35xYqT

Hi Blake,

Thank you for sharing this. I have take the liberty of moving this over to “The Lab” category.