Darkly Labs Community

Alarm Lock problems

Hey all,

I’ve already sent support a request with this, but thought I’d see if the community had any ideas as well as this has happened at just about the worst time of year for us (we’re already behind on cuts we needed for Christmas)

We’ve got an emblaser 2 that’s stopped homing consistently (it usually homes fine on the x axis, but not always the y) and if it has homed properly and I start a cut then it’ll tend to stop a couple of minutes in with a long constant beep and the console showing:

“WARNING: HOME the system before continuing
error:Alarm lock”

I’ve tried everything listed on https://darklylabs.com/article/alarm-lock-error-long-beep/ so was wondering if anyone had experience of other things that might be worth trying.

Thanks!