10W Focus Caloibration?

10w focus calibration?

I am about to attempt to install the 10W diode and assume that I’ll also need to do a focus calibration test. Are there special instructions for this unit or do I proceed the same as for a 5W?

Do I measure with the rubber mats in place or the honeycomb tray?

Hi Elayne,

Until the next official update to LightBurn, you need to use the rubber mats and just follow the usual 5w calibration process.

The new version of LB will allow you to select your silicone mats or Honeycomb tray for the calibration, but I am told the release is still a little while away.